CHOOSING THE STRATEGY OF INTERVAL TOLERANCES’ ASSIGNMENT

G.M. Shylo, I.M. Vesnin, M.P. Gaponenko

Abstract


Peculiarities of assigning the nominal tolerances for interval distribution law and changing the properties of components in the operation of electronic devices are considered. Interval coefficients of external influences, aging and simultaneous action of several external factors and placement of electronic components into devices are taken into account. The model of output function is formed for the worst case of external influence composition. To assign rating tolerances the coordinates of boundary points are recalculated to normal operating conditions. The optimal value of parameter deviations are obtained by equal tolerances, the maximum volume of tolerance region, the minimum cost and the optimal cost / quality relation strategies. Cost characteristic of electronic components are used. Volume tolerance is a measure of the quality. If it increases, manufacturing defects are reduced. The strategies of tolerance design are compared. Matrices of basic parameters and vertex of strategy coefficients are formed. To choose strategy the coefficients of design strategies are compared. To choose electric circuit the coefficients of tolerance design are used. The application example of proposed methods is given.

Keywords


interval tolerance, external influences, strategy, the minimum cost.

GOST Style Citations






DOI: https://doi.org/10.15588/1607-3274-2012-2-11



Copyright (c) 2014 G.M. Shylo, I.M. Vesnin, M.P. Gaponenko

Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

Address of the journal editorial office:
Editorial office of the journal «Radio Electronics, Computer Science, Control»,
Zaporizhzhya National Technical University, 
Zhukovskiy street, 64, Zaporizhzhya, 69063, Ukraine. 
Telephone: +38-061-769-82-96 – the Editing and Publishing Department.
E-mail: rvv@zntu.edu.ua

The reference to the journal is obligatory in the cases of complete or partial use of its materials.